How to transfer profile between eggs (bump uglies)
TouchConfig: Bringing Additional A700 Devices Online
Prerequisite: A single device has been configured. The following instructions are for configuring additional
devices.
Note: TouchConfig uses near field communication (NFC). Data sent through NFC is not encrypted nor
does it follow any specific safety protocol. This is because the transfer occurs over such a short range
that it is nearly impossible for data to be intercepted.
- Ensure that all devices are off.
- On the configured device, press and hold the Plus (+) button then press the Play/Pause button to put the device into sender mode. The ring's small segment will be solid yellow and the NFC indicator will blink yellow.
- On the unconfigured devices, press and hold the Minus (-) button then press the Play/Pause button to put the devices into receiver mode. The ring's large segment will be solid yellow and the NFC indicator will blink yellow.
- Turn each of the unconfigured devices so that the sides with the symbol are facing up.
- Hold the configured device so that the side of the device that has the symbol is facing down. Align the raised oval on the device with the raised oval on an unconfigured device. Ensure that the ovals are fully aligned, then hold the two devices steadily against each other.
- Watch the device state LED indicator ring on the receiving device to confirm configuration success or failure.
- Successful configuration transfer: The receiving device LED indicator ring blinks green for about two seconds, then the indicator signals the device reboot process (flashes red briefly, then rotates yellow around the ring, then rotates red.
- Failed configuration transfer: The LED indicator ring blinks red for about two seconds, then returns to receiver mode.
- Repeat steps 5 and 6 for any remaining unconfigured devices.